新闻分类

您现在的位置:首页 >> 紫外线灯 >> UVLED >> 光固化灯使用说明书

字号:   

光固化灯使用说明书

浏览次数: 日期:2017-06-24 17:04:58

UVLED 光固化灯系统产品使用说明书

 

Table of Contents

一、安全警告(Safety Warning)

、产品优势(Product Advantages

三、操作守则(Operation Rules)

四、冷却主机控制说明(Cooling mainframe control Introduction)

五、指示灯及数码管含义/(故障代码)Indicator & Nixie tube definition/ (failure code)

六、整机电器控图 Electricscontrol Diagram

七、产品保修卡 Warranty Form

一、安全警告

Safety warning

     1、请遵守操作守则。

Please follow the operating rules.

2、设备工作开机前请确认接入电源为交流 220V,并确认冷却水管各接头是否漏水。

Before start-up of the equipment, please confirm the power supply to be given is AC 220V, and make sure no water leakage with each joint of water pipes.

 

 3、开机顺序:请先确认冷却系统运行后再开 UV-LED 灯。关机时,请先关闭 UV-LED 灯组,三分钟后再关冷却系统电源。

Sequence of equipment start-up: First, confirm the operation of the cooling system, then switch on the UV-LED lamp. For stopping the equipment, close the UV-LED lamp group first, then switch off the power supply for the cooling system three minutes later.

 

        4、使用此设备环境温度必须在 30 摄氏度下。

  The ambient temperature for the operation of this equipment must be lower than 30 ℃.

         5、每周必须清理一次防尘网。

  The dust proof screen must be cleaned weekly.

    6、建议安装时与喷头距离 10 厘米以上。

It is recommended that the distance from the spray nozzle during installation should be maintained at more than 10 cm.

         7、必须使用防冻液。

Must use antifreeze.

二、产品优势

Product advantage

1、不含汞,更安全、环保。

Mercury free, safer and environmentally friendly.

2、芯片集成,集成度更高,可根据需求定制。

Chip on board assembly, and more integrated, can be customized according to the demand.

3、无需预热,即开即用。

No need to preheat, instant start-up and operation.

4、设备结构简单,占用场地少,安装方便。

Simple structure of equipment, less occupation of floor area, andconvenient installation.

5、直接水冷散热方式,延长使用寿命。

Direct water cooling mode of heat radiation, and longer working life.

 

6、冷光源,不产生有害紫外光;无热辐射,降低固化过程产生的热量。

Cold light source producing no harmful ultraviolet light; no heat radiation,reducing the heat generation in the course of curing.

7、发光效率更高,耗电量很小,使用寿命达到 10000 个小时。

Higher luminous efficiency, very small power consumption, and service life up to 10000 hours.

8、适用于多种基材:柔性或刚性,可吸收性非吸收性材料。

Applicable for many kinds of base materials: soft or rigid, absorbent or non-absorbent materials.

三、操作守则

Operating rules

1、连接 220V 电源线、24V 控制信号线、UV 灯组电源线及冷却循环水管。

Connecting the 220 V power cable, 24 V signal control line, UV light group power cable and cooling circulation water pipes.

      2、给水箱注水刚好到浮漂浮起,必须使用防冻液。

Feed water into the water tank till the buoy floats, you must use the an tifreezing.

 3、打开总电源开关,确认水泵运行,运行 35 分钟,排出管路中的空气,按控制面板开关,启动冷却系统。如控制面板显示 E06 则水箱水不够,E07 则是冷却水循环不顺畅或水管折弯。

Switch on the main power supply to confirm the operation of the water pump, and keep it running for 3 to 5 minutes to let out the air inside the pipeline, then press the button of the control panel to start up the cooling system.If the control panel shows E06, it means the cistern short of water, or E07 it means cooling water circulation is not

gghsysmsuvled使用说明书

uvled光固化机使用说明书uv光使用说明书uv光固化机使用说明书光固化机使用说明书光固化灯使用说明书LEDUV说明书uvled使用说明书uvled设备使用说明uv led使用说明书光固化灯使用说明书uvled使用说明书uvled固化设备使用说明uvled使用说明uv固化设备使用说明LEDuv使用说明书LED uvuv LED使用说明书UVLED光固化机使用示意图光固化灯使用说明书保修卡

上一篇:UV机

下一篇:光固化机怎么用

所属类别: UVLED

该资讯的关键词为:光固化灯使用说明书 

相关资讯